Get a Stratux
Buy a receiver that's ready to fly, or build your own from a kit. Both run the same free, open-source software.
Ready-to-fly units
It's assembled, tested and ready to use. Plug in power, connect your tablet, and you're good to go.

DIY kits and parts
A full kit has everything you need to build a working receiver. If you're flying in Europe, read Stratux in Europe first. Our build guides walk you through it, and Build your own ADS-B receiver explains what each part does.
Core and replacement parts
- Raspberry Pi: 3B, 3B+ or 4. The 3B and 3B+ are the standard choice. A Pi 4 works, but it runs hotter and draws more power.
- Stratux 1090ES and UAT low-power radios with high-gain antennas
- UAT radio
- AHRS 2.0 board and fan controller
- Pre-programmed microSD card or a blank microSD card to flash yourself
- White ABS case for Pi 3B and 3B+
- Fan and heat sinks
GPS
- Internal GPS: works for most window mounts.
- External GPS or a removable GPS puck: better in cockpits with a metal roof or poor sky view.
Antennas
See Antennas for which port is which and how to fit them without damaging the internal cables.
Mounts and cases
Power: batteries, cables and chargers
You'll need a 2 A or better power source. Weaker supplies cause reboots. See Power and status lights.
- Slim battery packs (alternate)
- High-capacity battery pack (alternate)
- USB cable with on/off switch and 90° connector
- Braided micro-USB cable (alternate)
- USB car/plane charger (alternate)
- Wall power supply (alternate)
Accessories
- Serial adapter for panel displays that take GDL90 or FLARM NMEA over serial
- Splitter and SAW filter
- Tool kit: screwdriver and wrenches
Next step
Once your receiver has power, follow Getting started to connect your EFB.
Some links on this page are affiliate links. Purchases through them help fund the project, and they don't cost you extra.